mainad | Posts: 15

Signature position and dimensions

Wednesday, February 3, 2016 at 11:49am
0 votes
Hi Silanis team- I cannot find any documentation on the unit of measure used for the Signature block position (X,Y) and dimensions (Height,Width). Is it pixels? Points? Inches? Also, if anyone knows/remembers-- we are currently using Version 4.x / hosted of the Silanis framework. Has the unit of measure changed between this and cloud-version 6.0 Enterprise? Given the same values, the Signature shows up in different places in 6.0. Thanks for any input, =maina)
Approved Answer
mwilliams | Posts: 957

Reply to: Signature position and dimensions

Thursday, February 4, 2016 at 05:32am
0 votes
It is points. The scaling factor of 1.3 is correct as well. Let me know if this helps get everything lined back out properly. :)
mwilliams | Posts: 957

Reply to: Signature position and dimensions

Wednesday, February 3, 2016 at 12:17pm
0 votes
I believe it is points, but I will double check. As for differences between 4.x and current, I am not sure as I wasn't around in the 4.x timeframe. However, I believe there is a multiplication factor in there of 1.3 that needs to be included to get the value you're expecting. This could have come about between your versions and could be causing the difference. You might give it a try and let me know. I'll check on the multiplier to be sure it is definitely 1.3.
mainad | Posts: 15

Reply to: Signature position and dimensions

Thursday, February 4, 2016 at 05:40am
0 votes
Thanks for your quick responses, Michael! I'll test that ratio today and will report back... =maina)
mainad | Posts: 15

Reply to: Signature position and dimensions

Thursday, February 4, 2016 at 10:03am
1 votes
Michael- thanks for your help. This factor seems to work well, and we'll be using it going forward. Thanks, =maina)
mwilliams | Posts: 957

Reply to: Signature position and dimensions

Thursday, February 4, 2016 at 12:30pm
0 votes
Great to hear! Let us know whenever you have questions!

Hello! Looks like you're enjoying the discussion, but haven't signed up for an account.

When you create an account, we remember exactly what you've read, so you always come right back where you left off

LoginSign Up